Scholarlink

The following study analyzed the effect of the 3D printer setup of the samples on their tensile strength. The samples were fabricated by SLS using PA12 powder. The main objective was to determine the appropriate alignment of the model in the 3D printer to obtain the desired mechanical properties in future prints. According to the results of the study, for flexible parts the best print layout would be at 45° vertically, and for parts that do not require flexibility vertically.

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Analysis of the Impact of the Model Setting on the Material Properties of a Component Uproduced by the SLS Method

  • 会议论文

  • 发表日期：

    2025年

查看全文
  • Kamil Joszko,
  • Dominika Ślimok,
  • Wojciech Kajzer,
  • Katarzyna Jochymczyk-Woźniak

摘要

The following study analyzed the effect of the 3D printer setup of the samples on their tensile strength. The samples were fabricated by SLS using PA12 powder. The main objective was to determine the appropriate alignment of the model in the 3D printer to obtain the desired mechanical properties in future prints. According to the results of the study, for flexible parts the best print layout would be at 45° vertically, and for parts that do not require flexibility vertically.