Scholarlink

<p>Laser cladding technology was used to fabricate a ZCuAl8Mn13Fe3Ni2 cladding layer on a ZCuAl8Mn13Fe3Ni2 cast alloy substrate. A comparative study was conducted to analyze the microstructure and properties of the laser cladding layer and the cast alloy. The experimental results revealed that the ZCuAl8Mn13Fe3Ni2 cladding layer primarily consists of a Cu-based face-centered cubic (FCC) solid solution (α phase), a body-centered cubic (BCC) solid solution (β phase), a complex cubic γ<sub>2</sub> phase, and an intermetallic κ phase. When the laser cladding process parameters were set to a laser power of 1600&#xa0;W, scanning speed of 6&#xa0;mm/s, powder feed rate of 2&#xa0;rpm, and gas flow rate of 3.5&#xa0;L/min, the average Brinell hardness of the laser-cladded ZCuAl8Mn13Fe3Ni2 layer was 278 HB, with a corrosion current of 3.73 × 10<sup>−2</sup> mA/cm<sup>2</sup> and a corrosion potential of −0.271&#xa0;V. Compared to the cast alloy with the same composition, the laser cladding coating exhibited a 14.88% increase in hardness, an 18.68% increase in corrosion current, and a 1.88% decrease in corrosion potential.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Laser cladding remanufacturing of propeller ZCuAl8Mn13Fe3Ni2 alloy

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2025年4月11日

查看全文
  • Pi Ziqiang,
  • Du Kaiping,
  • Chen Xing,
  • Zheng Zhaoran,
  • Wang Chen

摘要

Laser cladding technology was used to fabricate a ZCuAl8Mn13Fe3Ni2 cladding layer on a ZCuAl8Mn13Fe3Ni2 cast alloy substrate. A comparative study was conducted to analyze the microstructure and properties of the laser cladding layer and the cast alloy. The experimental results revealed that the ZCuAl8Mn13Fe3Ni2 cladding layer primarily consists of a Cu-based face-centered cubic (FCC) solid solution (α phase), a body-centered cubic (BCC) solid solution (β phase), a complex cubic γ2 phase, and an intermetallic κ phase. When the laser cladding process parameters were set to a laser power of 1600 W, scanning speed of 6 mm/s, powder feed rate of 2 rpm, and gas flow rate of 3.5 L/min, the average Brinell hardness of the laser-cladded ZCuAl8Mn13Fe3Ni2 layer was 278 HB, with a corrosion current of 3.73 × 10−2 mA/cm2 and a corrosion potential of −0.271 V. Compared to the cast alloy with the same composition, the laser cladding coating exhibited a 14.88% increase in hardness, an 18.68% increase in corrosion current, and a 1.88% decrease in corrosion potential.