Scholarlink

<p>In thermal barrier coatings (TBCs), different stabilizing compositions are preferred to increase the strength and optimize the thermal expansion coefficient of zirconia-based ceramic top coatings. In this study, TBC systems containing ZrO<sub>2</sub>-CaO (CSZ), ZrO<sub>2</sub>-MgO (MSZ) and ZrO<sub>2</sub>-Y<sub>2</sub>O<sub>3</sub> (YSZ) were produced by atmospheric plasma spraying (APS) method and solid particle erosion (SPE) tests were performed at 30°, 60° and 90° impact angles in accordance with ASTM G76-95 standard. In tests using alumina powders, it was determined that erosion behavior is closely related to microstructural properties and mechanical strength. At low angles (30°-60°), the sliding of particles along the surface led to stress accumulation at lamellar boundaries, microcracks and especially in interconnected pores, which increased the wear. In addition, low hardness and high surface roughness reinforced this effect. In contrast, YSZ coatings exhibited the lowest wear rate at 90° impact angle due to their higher hardness, low interconnected pore content and uniform surface morphology. The results revealed that microstructural integrity and mechanical properties play a decisive role in the erosion resistance of TBC systems.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Assessment of the solid particle erosion resistance, microstructure and failure mechanism of calcia, magnesia, and yttria-stabilized zirconia thermal barrier coatings

  • 期刊论文

  • 发表日期：

    2025年9月8日

查看全文
  • Yıldız Yarali Ozbek,
  • Dervis Ozkan,
  • Sefa Erdem Yilmaz,
  • Gulfem Binal,
  • Yasin Ozgurluk,
  • Okan Odabas,
  • Abdullah Cahit Karaoglanli

摘要

In thermal barrier coatings (TBCs), different stabilizing compositions are preferred to increase the strength and optimize the thermal expansion coefficient of zirconia-based ceramic top coatings. In this study, TBC systems containing ZrO2-CaO (CSZ), ZrO2-MgO (MSZ) and ZrO2-Y2O3 (YSZ) were produced by atmospheric plasma spraying (APS) method and solid particle erosion (SPE) tests were performed at 30°, 60° and 90° impact angles in accordance with ASTM G76-95 standard. In tests using alumina powders, it was determined that erosion behavior is closely related to microstructural properties and mechanical strength. At low angles (30°-60°), the sliding of particles along the surface led to stress accumulation at lamellar boundaries, microcracks and especially in interconnected pores, which increased the wear. In addition, low hardness and high surface roughness reinforced this effect. In contrast, YSZ coatings exhibited the lowest wear rate at 90° impact angle due to their higher hardness, low interconnected pore content and uniform surface morphology. The results revealed that microstructural integrity and mechanical properties play a decisive role in the erosion resistance of TBC systems.